ErGear Dual Monitor Arm Desk Mount for 17 to 32 Inch Screens, Dual Stand for Curved Flat Screens, Double Monitor Arm Support VESA 75/100 mm

I'm very happy with the dual monitor stand! I was afraid I was going to have to drill into my desk as edge of my desk has beautiful molding and the c- clamp could not fit flat as a result. However, I was able to trim a piece a wood to fit the molding underneath the c- clamp to have a flat grab. It works great and saved me from putting a hole in a beautiful desk.The stand is terrific. Moves very well and is quite durable. Elbows are easy to tighten or loosen if needed. I have two 27" monitors and I'm so happy to have this vs the individual stand. My desk is now more available and looks great as the furniture is shown off more.I'm very happy with this, that I bought a second one for my dad.

I bought these arms when I realized my new monitor was too heavy for my old set. This set was significantly easier to set up and is waaaaaay sturdier than my old ones. I'm very pleased with my purchase.Only complaint is the wire covers are extremely awkward to get set up, but it could be just a me thing. I'm not very DIY-inclined, so I'm sure most people had an easier job than I did with them. Wasn't even a big enough deal to knock stars off. 5 star item, especially on sale.

Ist auf jeden Fall eine sehr geile Monitor Halterung, nur für meine Persönlichen Zwecke sehr ungeeignet da sie von der Wand her sehr viel Platz braucht und das hat mich einfach gestört und hat mir einfach den Raum weggenommen. Im großen und ganzen kann ich sie aber natürlich empfehlen.

Overall very pleased with my purchase. This elevates my monitors which improves my neck pain during longer sessions. It also enables me to spin them 180 degrees as needed for work. Very easy to assemble and attach to my desk.

Overall this is a really good mount. The range of motion and sturdiness are great. Also, it has a very small footprint and allows for a really clean work environment. There are two design flaws that makes installation difficult.1- The hardware provided to attach the Versa plate is not useful. If you have to use the spacers to prevent the plate from being recessed the screws provided are either to long or to short.2- When attaching the monitor to the arm the holes that the knob goes through are not flush because of the bottom of the plate has a catch that prevents it from sliding all the way down. As a result, you have to use a pair of pliers to torque the knob hard enough to secure the monitor (see picture with red markings).3- The cover for the cables on the bottom of the arm have to be removed and reattached are not accessible while the arms are attached to the base. It does not give enough clearance to fit a screw driver. I had to remove the monitors, unattach the arms then route the cables and secure the cover.