JOYLIT24V 32.8FT/10M COB LED Strip Lights 120° 2700K Warm White Indoor 384LEDs/M High Density 7650LM Super Bright CRI 90+ Dotless Adhesive LED Tape Light for Bedroom, Kitchen, Commercial

The media could not be loaded. Brightness is off the charts and looks awsome but not for the average homeowner. I and a professional electrician and took me full day to install. I used the led aluminum track and lens system to make them water proof and a 150w drive and rgb controller with remote. All purchased thru amazon

Was able to add it to above our cabinets to add more ambient light. Now it’s the main light we use since it Lights up the room without being overpowering brightness

90+ cri which is what mattered to me

no way to plug into wall and came with no adapter or instructions not easy to use.

First of all, to the reviewer complaining that this LED tape light didn't come with "no way to plug into the wall" and "no adapter" and "no instructions", well no duh. The product listing clearly says that it doesn't include a dimmer or the required power supply. The third photo also clear states that the power supply and dimmer are not included. So why would you complain that you didn't get something that wasn't included? As for instructions, if you don't know how to use a bare roll of LED tape light, you shouldn't be ordering a bare roll of tape light. It's pretty straight forward, but this is not a starter set, it's for people that have a clue how to use this.As for the actual tape light, it is nice and bright, it dims well using the 24 volt LED driver I have and the Lutron Diva DVCL-153P dimmer switch. At barely over $1.00 per foot, I think that this represents a good value. However, my roll showed up with nineteen soldered splices in it. What that means for the uninitiated, is that this 32 foot roll is made up of shorter lengths that have been soldered together, rather than being one continuous, uninterrupted length. I have purchased rolls this long with no splices, so I know it's certainly possible, but I suspect it's more economical for some manufacturers to have lower quality standards and chop out the bad parts and re-solder the good parts. Does it make a difference? Hard to say, but if you want to cut the tape light where a solder splice is located, it's a little more difficult (ideally you unsolder the joint). And in my mind it does represent a potential point of failure; as the splice heats up and cools down over many power cycles, a weak solder joint could ultimately fail. I wouldn't quibble over a couple splices or so in a roll this long, but nineteen of them seems very excessive to me.Only you can decide whether the value price makes up for this many splices.

Ich habe mir diesen Stripe bestellt, weil ich bereits ein Aluminiumprofil hatte und dort noch einen homogenen Stripe einsetzen wollte, um eine Wandlampe zu bauen. Dies war mit diesem Stripe Problemlos machbar. Einfach an das Schaltnetzteil angeschlossen und fertig. Ich brauchte in diesem Fall genau zwei Stücke und konnte somit die Werksseitigen Anschlüsse an beiden Enden der Rolle verwenden. Hat man das nicht bzw. braucht kleinere Einzelstücke, muss man natürlich auch löten können.

Super Innenbeleuchtung

Schönes gleichmäßiges Licht