Aluminum Cup Wrench for Removing Toyota Oil Filter Caps, 64mm Flute, Fits 2.5L to 5.7L Engines, Black

This oil cap remover fits perfectly on a 2012 Toyota sienna van. I used to 27 mm socket to operate the oil cap remover and it worked perfectly! I also used it to reinstall the old cap which required 28 foot pounds on the torque, but you can just make it hand, snug.

Works as advertised this product fit my Toyota Camry oil filter housing. The notches all lined up perfectly. I would recommend this product and buy it again if needed. Well built and strong. Worth the money

Good

Must engage this filter cap wrench in the correct placement of the slots that go over the "fins" that are on the Toyota RAV-4, Tyota Tacoma or Lexus RX-350 oil filters. Otherwise one could damage not only the filter housing, but the oil filter cap removal tool as well.

It would have been impossible to remove the cap without the tool without damaging the cap. The cap is made of plastic and can be broken or damaged if pliers were used for removal.

I bought this hoping to use it for work when the first time I used it, it shattered when a large amount of pressure was applied (a breaker bar with a pipe) I will not be buying this again

This did the job that another more expensive fancier filter wrench failed to do! Was changing oil on 2021 Tundra after free Toyota oil change was done. The filter housing had been tightened in there with the strength of Zeus himself! Breaker bar along with this wrench nudged it out one notch at a time! The other mention more expensive fancier wrench would get stuck on the housing because it had no notches. This one was just right! Should hold up well over time too from the looks of it. I used a 27mm socket on it.

Excelente