VEVOR1.5HP Electric Motor 3450 RPM, AC 115V/230V, 56 Frame, Air Compressor Motor Single Phase, 5/8" Keyed Shaft, CW/CCW Rotation for Agricultural Machinery and General Equipment

Ordered mid-week and this motor arrived on Friday. I could not believe the speed that this motor shipped out at! It was installed on a 44-year-old Craftsman table saw and ran perfect. I did have to change wiring as indicated on motor so that the belt rotation was reversed. The motor was very heavy and I am pleased with this purchase. Also it was a great value and easy to install.

I bought it as a replacement motor for my Sears - Craftsman 10" Table Saw. The specs matched with regard to 1.5HP and 3450 RPM and another reviewer said it was a direct-bolt replacement. Having said that, the motor comes with 6 internal wires and a ground terminal all which need to be wired to your own 3-wire cord. It's up to you to decipher the chart as to whether you're going to run in 120v or 230v, as well as Clockwise or Counterclockwise rotation. So, you'll be staring at the chart for that a while and basically figuring out which 3 wires go to the hot wire of your own cord and which other three go to the neutral (for two sets of 4 wires nutted together total). The directions say it's pre-wired for 120v but, after studying, mine was clearly set for 230. It also hinted that it may be set for Counterclockwise rotation but mine was clockwise. Other than that, the motor is larger than my original and did bolt up fine however, the larger motor size pushed the shaft sideways out of alignment with the pully on the table saw. I simply flipped the pully the opposite direction on the motor to ride closer to the motor housing and got both pullies to line up. Minor note: Since the motor comes with a wire box and punch hole for your power cord, I wish it came with a cable clamp for the box.Looking forward to another 30 years of use out of my table saw.

The media could not be loaded. It's big, It's heavy duty. It's a little light on the low end torque.

I ordered this specifically to convert my contractor style table saw over to 220v. Easy to follow wiring instructions. Great upgrade!

Yes, it works good! Thanks, Gene

Great motor. Easy to wire in.

I put in on my drill press cause the motor that was on it wasn’t powerful enough .

dislikegets realllly hot....low torque