AmeriTop Solar Lights Outdoor, 2 Pack LED High Brightness Cordless Solar Motion Sensor Lights; 3 Adjustable Heads, 270° Wide Angle Illumination, IP65 Waterproof, Security LED Wall Light(Daylight)

These lights are BRIGHT!. I have a 3 car garage and just one set easily lights my whole driveway.They came with a partial charge allowing testing before installation. All hardware is included and instructions are pretty good though an install template for the base that the light clips on would have been an even better piece to have. Perhaps this can be included in future shipments. Installation was otherwise pretty straight forward though some basic DIY skill will be needed particularly if you are installing on brick or cement (cinder block) since a hammer drill would then be needed. I suggest that is using a hammer drill on cinder block start out with a 3/8 bit instead of the suggested 1/4" and then carefully enlarge as needed since with cinder block the drill can move causing the hole to get too large. Installing on wood or similar material should prove super easy, though.The motion detection is really good and the lights can be adjusted somewhat to alter the area covered by the light. The solar detector, however, is fixed in position so be sure to install this where it can receive good sunlight. Our house faces south so it works perfectly for us.I have to say that I am more than satisfied with these two lights The price point, especially considering that two lights are provided, is another plus. They look to be pretty durable, as well, compared to similar lights.I want to offer an installation suggestion when installing on cinder block in order to assure a level light base.:Drill the top hole first, place the anchor and then screw the base in loosely. Then, use your leveling tool to get the correct spot to drill in the two lower holes. I would get the base in place and use a small drill bit to start the hole through each of the base screw openings. You can then swing the base up and out of the way while it is still attached at the top hole to make the correct larger hole size in the two lower screw holes, put in the anchors, let the base fall back in place over the new holes and put in the screws.The instructions say to use a marking tool (pencil, etc) but holding the base level and in place while trying to correctly mark the holes was difficult for me. Getting the base held loosely in place via the top whole made the process much easier. Perhaps this will not prove difficult for others, though.Feel free to ask me any quesionts. In summary, though, I am really happy with these lights.

These lights are awesome. They are very bright and light up my small yard completely. I recommend this product. I have now bought 2 sets and plan to buy another for my new deck.

*UPDATE 10/18*:I wanted to edit my review. The lights do NOT come on in the daytime. I installed one of the lights on a tree, and if there's enough shade from the branches, the light will illuminate. But the lights do not turn on in broad daylight in the full sun, which is good.ORIGINAL:Very easy to install and operate these motions lights. For the price for 2, it’s worth it. I like that there’s only two modes: off and on. They’re bright enough to light up a walkway or an area of a yard. I actually installed one of these on a tree in my front yard. The only things I don’t like are that the solar panel only moves up and down. It should be able to rotate horizontally as well to find the best position for the sun. Also, these lights work in daylight as well, which isn’t necessary most of the time. So I wish they only turned on during low light. Other than that, I will be ordering two more for the price and ease of use. But a 2.0 version with those changes would be great.

The media could not be loaded. 2 for $30ish super satisfiedA ladder1 drill bit (optional)1 screw driver or 1 drill or 1 impact driver for screwing in screwsSuper fast and easy installation.1 rectangular plastic mount with 3 holes for screws. (I used 1 screw for both lights but I have an impact driver that tightly fastens the screw into the siding. You may need to use atleast 2 screws. Directions call for 3. Comes with 4 screws and 4 plastic supports for certain materials.After securing the plastic mount you simply slide on the light the inserts are on the edge of the solar panel. There is not a lot of room for adjusting the lights if you mount them like I did completely up against the side of my house instead of letting it hang down clearing any obstacles.Do that and you'll have about 360 degree adjustable. But don't quote me on that because I'm assuming. I did not try this.As I'm writing this I see my lights being tripped. I haven't made any fine tuned adjustments yet.(Edit) I left out a feature.So as you see theres 3 led lights.The center light is attatched to swivel from the solar panel.The left and right LED lights are attatched to each side of the center light so they both turn and swivel independently of each other! they also slant angled away from the center light covering a bigger surface area3 days now no issues working great it has rained still super bright. The fact they turn off quickj and don't get tripped much pretty much means they stay well charged and bright.Last the daylight sensor is very sensitive which is great for preventing accidental trip. but as long as it's dark the motion sensor works everytime.If im out with a flashlight and the light don't trip i turn my back to the light (so the flashlight is facing away) and it lights up no problemONCE AGAIN.I will update this review IF I have Any problems

Works well, haven’t install as yet

practical installation and meets the description

We bought these as a replacement for another set that lasted a year.One of these began to lose its charge after only eight months of use.When they worked, they were brilliant. And they held their charge all night. Too bad there's no way to replace the batteries.

These are wonderful for emergency power outages. They charge quickly and are bright for the home.