Lofekea Wall Mount Toilet Paper Holder Stainless Steel Tissue Paper Roll Towel Holder Rustproof Brushed Finish

Finally an easy load toilet paper holder that my wife and kids can't break (yet).I replaced a different brand we got at the local HW store that used a tiny set screw to try to hold it on and it was always getting loose. This one is a much better design.I didn't use the screw cover caps it came with or the drywall screws (they both looked cheap). But bracket itself is spot on what I needed. Thank you!!!

Nice and sturdy. Actual metal. Easy install! A 90 degree drill/screwdriver attachment makes it even easier. Bought another one.

This is a pretty nice-looking roll holder I got to replace a broken Ikea GRUNDTAL that had the rear weld fail, and is no longer made. The new BROGRUND just doesn't quite match the other GRUNDTAL stuff, so I ended up finding a load of needlessly expensive holders until I stumbled across this one.This design will be a LOT more durable than Ikea's as it doesn't rely on a spot weld and instead is a single bent piece of stainless steel. I ended up re-using my GRUNDTAL cylinder to match the towel holder, etc since it has a much larger diameter. That cylinder's diameter matches the width of this holder, so it was a perfect fit as well. My design introduces some snag with EXTRA large rolls, but this is NOT a problem if you stick with the thinner diameter cylinder it comes with.I also countersunk the installation holes so that the flat-head screws would be flush with the surface, instead of using the included supports and covers.Simple and looks great.

Love this holder Limited space in basement bath to hang without being in way. Perfect solution to hang on skinny wall between toilet and shower next to itTools needed: Phillips head screwdriver. A nail and hammer (to create pilot hole for screw).. I elected not to use the plastic drywall inserts for screws since holder is lightweight. Screws screwed tight into wall without themCaution- remember to put washers on before s teeing in screw- these hold the buttons to hide the screw headPosition the washers so that the insude concave curve is facing you (as if you were looking into a bowl- see photos)The caps fit snuggly over the washers if you hold cap level and apply even pressure all aroundSteve in CT .

Ok, but too short for a roll of toilet paper to sit on it properly.

I went to install the toilet paper holder and had to remove the roll bar for a more accurate screw drive. The allen wrench that was included in the hardware envelope was too small to loosen the allen screw. fortunately, I had an assortment of allen wrenches that fit the allen screw to remove and reinstall the roll bar. There was no Quality Control Department at Lofekea company or they would have caught the improper size allen wrench.

I like this particular paper holder because it’s sturdy and it is non-descriptive

Genius ikea Grundtal toilet roll holder replacement … $14 and a little switch-a-roo and Voila!Like a few of you I too had an ikea Grundtal whose single weld broke and you can’t get that puppy for a realistic price (found one in the UK for about $90 - REALLY?AND I So hate the tiny, thin - too long roll spindle this unit comes with! GEEEZ!But hey! this unit re-uses 1 of the two original screw holes - and you only have to make a new one to hang the unit - and fill one…AND THE GENIUS PART…? Turns out that No FUSS no MUSS you can EXCHANGE THE perfect Grundtal spindle for the one this unit came with and voila!Better yet - because this one is bent Stainless and not depending on a flaky weld - we probably wont be re-fixing the same problem in the future :)Not bad for $14 and 15 minutes of screwing around!