uxcell Keyless Drill Chuck MT3 Morse Taper Mount Adjustable 1/32"-1/2" (1mm-13mm) 3-Jaw for Lathes Milling Drilling Machine

Worked great with both my drill press and my metal lathe.

For the money - this drill chick is near unbeatable. This is perfect for center drills. Keep it “loaded” and near the lathe, stored in a collet rack.The depth is a bit odd so longer drill bits and reamers may not work but likely shouldn’t be used in this holder anyway.Fit and finish is surprising for the money and the MT3 taper (with a tang) is well sized.

Bought to use in my home shop on my wood lathe tail stock. I’m ordering 2 more, one to use on the drive side and the other to replace the stock one on my ShopFox drill press. I use the USA Jacobs original at work, they are awesome but they also cost about $325. These are 1/10 the price and I would say 98% of the quality. It works flawlessly, the paws are machined extremely well, whichever Chinese factory made these is doing excellent work!

Replaced the factory chuck and arbor that came with my brand new drill press with this one, the stock chuck and arbor that was supplied with my drill press was horrible as most are, what a difference, it’s night and day in performance. The one I installed has very little run out and the action on the chuck is buttery smooth. I can’t believe the cost of this compared to some more pricier options. As far as longevity, I don’t see this wearing out all to soon, the machining seems to be very good. I was a bit leery because of the price being so reasonable, but this set up has exceeded my expectations. I don’t think you can go wrong with this one.

like that it will hold the smallest drill bit for drilling ornaments and hold up to 1/2" drill bits for drilling on the lathe.It is so much more handy to change out bits and dowels than the keyed chucks. Its very heavy and helps dampen the vibrations in the lathe. I should have ordered one with a threaded hole in the MT-2 end so that it could be locked into the head stock when using it as a driving chuck for turning tops that use a dowel in the center of the blank.

I needed to perfection-precision clean "both sides" to get the chuck to stay in, but clean and dry plus a couple taps and stays in just fine. Works perfectly and amazingly perfectly true. Killer value!

worst chuck ever keyless but get the vice grips to tighten or loosen,,, and if the shank on your bit is like a double ended centering tool forget it bits must be flush on the end to shallow to hold them straight,,,i bought a cheep chuck 100 x better then this one save your money buy the cheep one with a key,,,

Great improvement to my stock chuck with key. Was recommended in a review for the drill press to upgrade for accuracy and spot on! Very happy with the purchase.