E-outstanding 25-Pack Copper 5mm Light Emitting Diode LED Bezel Holder - Round Lamp Emitting Diode Mount Panel Display Socket Base

LED fits snuggly......makes for a nice finish. If you have LED's with resistors pre-fitted you could just omit the plastic piece & use a dab of silicone sealant/adhesive to secure it.

I like these a lot. They remind me of the panel mount holders that Radio Shack used to sell a long time ago. They are solid metal and are quite rugged. They come with a plastic non-conductive LED insert (necessary because everything else is conductive), a metal lock-washer, and a metal retaining nut. To use these you drill a hole in your project panel just large enough for the threaded base to fit through. Then insert a 5mm round LED into the threaded base, slide the plastic retainer over the LED leads, and firmly push the plastic retainer into the base. Remove the nut and lock washer, insert the mounted LED into the front panel of your project and install the lock-washer and nut. I was originally concerned that the plastic insert would not stay in place, but after installing an LED it was very difficult to remove. I'm confident the LED will stay in place against all but the most severe abuse. Be sure not to over-tighten the retaining nut as it's not machined tightly enough to withstand a lot of force. Tighten until snug and the lock-washer will keep it in place.

I was just hot gluing the led bulbs in when making indicator panels. These make for a nice finished look when panel mounting your LEDs. The light panels were to indicate where model trains were inside of large tunnels and which tracks were active so other trains could pass. They come in 2 different sizes depending on the size of the bulbs.

These bezels really improved the look of my control panel. Drill the hole, insert the bezel, and tighten the nut on the back side. The plastic stoppers have holes for two leads, and they hold the light firmly in place. Note, these will not work with common cathode bi color LEDs that use three leads.

Very nice LED holders. Nice construction, nice finish and easy to use.

Used this for a guitar build to have the LED light held in place and look more professional. This got the job done and looked great and didnt cost much.Pros:1)Good Price2)Looks Professional3)Works with any LEDCons:1)None I can think of

Overall an excellent value in LED bezels. With the plastic insert, the LED will be firmly held in place in the bezel. I am going to use them without the insert because my LEDs will be on a circuit board. These bezels appear to be good quality and look good.

Nice product