Gwisdom CR-10/CR-10S Magnetic Bed, Upgraded Ultra-Flexible Removable Build Surface 3D Printer Heated Bed Cover, 300 * 300mm

Been looking at a flexible build plate for a while now as a direct replacement for the current glass bed with glue stick I useThe build plate is perfectly sized for the cr10s and is of great build qualityPrinted on this surface 5 times now and every print has stuck without the need for glue. And removing the prints is no longer an issue take of the magnetic top and peel away from your print with easeOnly con... The way this is shipped is very poor could do with being supported with some thick cardboard and the top layer does have a kink due to being damaged during ship..

When printing wide objects that covers almost all the print bed, the top bed warps up. Scratches easily

Ok for smaller items. Anything with a large base that can shrink during printing tends to lift off the bed if properly adhered. Magnet not really strong enough.Small prints are good though.I am still using it but have now ordered a glass bed for larger flat faced prints

Gave this product a do as I was using tape on a glass bed and glue to stick my prints. I wanted to try something that required less setup and cleanup and saw this. Saw similar products being used on an Ender 3 and felt it could work on my Creality CR10S. It didn't.First off the product comes in 2 parts. A stick magnetic bed that covers all of my glass bed for full adhesion. That part was great, the adhesion was good although I didn't get the chance to try out how long term heating and cooling affected the adhesion. The second part is what gets printed on to. It has a matt finish and is supposed to lie flat on the magnetic portion of the bed, being held in place my the magnetism. My product must have been defective or bent in storage however because the top part would not lie flat. It would rise up and bump, pushing it down would just make it pop back up again. Ideally it would have been laid flat however it feels like it may have been creased in storage perhaps? Either way it wouldn't lay flat.This could be why my prints failed to stick. Parts of the mat that were flat, the print stuck, areas where the mat rose up it didn't. I reckon the product would have worked fantastically if the mat fully lay flat. Although after ordering I can see how easily this product can get bent (It was just shipped in a regular amazon box, meaning it isn't stored in its own for protection) and that anywhere from delivery to the warehouse and handling in the warehouse it can render it useless.

Great product. Really helps with 3D printer adhesion in my CR10S. 5 stars are not only for the product, but also for the seller. There was an issue with the product initially, and even though this seemed to be a manufacturing issue (product was missing a part) the seller had no issue resolving the problem for me swiftly and efficiently. Communication was also great.

Magnet appears OK however after the first HIPS print there is no adhesion and curling is ruining all HIPS prints. Would not recommend.

Had it a few months now, the adhesive/magnetic side was ruined almost instantly on installation and it almost destroyed my build plate in the process, prints don't stick to it at all and it messes up levelling the printer due to the poor lip placement.Outside my return window as my printer was out of action for a few weeks before I had the chance to try out the mat otherwise I would have returned it. Complete waste of money

Using PLA and every print has stuck to the top surface but not in a good way. Top surface now deformed and useless - it looks to me that it can't deal with the temperature of the plastic and it actually ends up melting as the plastic hits it. Waste of time and money.