EZDIY-FAB 120mm Addressable RGB LED PWM Fan,with LED Strips, Motherboard Sync,Adjustable Colorful Case Fans with PWM Controller

Works great, easy install and exactly what i wanted, might purchase 1 additional fan and 2 more strips again. Connects to my asus tuf x570 pro motherboard argb header so i can control it with aura sync using Armoury Crate, greqt price as well, not very loud either when i turn the fan speeds up to Full speedwhen playing warzone to keep processor below 40°C temperature.

I got these fans for my AIO cooler when I realized the other EZDIY-FAB fans I got were not PWM and I didn’t want to run fans on my radiator without speed control.These are a pretty good match for the double ring aRGB fans BUT (there’s always a “but” isn’t there?) they are single ring fans with the LED ring on the intake side.Depending on your case and whether you’re pushing or pulling air the LED ring can end up on the wrong side of the case and not look very good. As far as I can tell the assembly is not reversible so if they’re not blowing in the direction you need they’re not going to look very good with the LED ring on the inside rather than outside.In my case in a Lian Li 011 case I’m blowing air through my radiator at the top as exhaust fans so the the LEDs face the right way but the rest of my case fans which are pulling air into the case would end up with the LED ring inside against the mounting holes and the fan frame would block most of the light so I couldn’t use them there and had to stick with the dual ring non-PWM fans for that.These fans do a decent job of keeping air moving. They top out at ~1750 RPM and at 100% you can hear them but they’re not awful. I have 3 in my radiator.In my case most of the time they’re running at 800 RPM not really noticeable until they hit 60-75% speed.Sync with Mystic light works through the controller but all fans and strips will run simultaneously. They can also be daisy chained and connected directly to aRGB headers. If you want them to run in sequence you have to daisy chain them to the argb header on the motherboard and since each header only supports 72 led’s and each fan has 18...you can only address 4 of them per header although the fans DO have nice passthrough cables that let you daisy chain the argb cables without any additional adapters.I ended up using the controller to aggregate the fans and then connected the controller to my argb and fan speed control header as I have way too many fans to control individually.My only complaint and what keeps me from giving these fans a 5 star review is that they are unidirectional and the LED ring can end up on the wrong side of your build which is too bad.

These fans, like any fans, are easy to install for anyone with a basic knowledge of computers. The hub makes adjusting the speed of the fans easy plus it is aura compatible right of the box. ***NOTICE: DESPITE THE OTHER REVIEWS, THE 3 PACK WITH THE ADDRESSABLE RGB HEADER IS ASUS AURA COMPATIBLE, BE SURE TOY GET THE RIGHT ONE IF THIS IS IMPORTANT TO YOU***The LEDs are nice bright and the included strips add an extra flare to really light up your case. I was able to attach two to my 240 AIO radiator with ease and the third in the rear for heat exhaust. Not a bad price for quality

They look pretty and that's about it. One of the fans just doesn't spin. Luckily I only needed 5 and ordered 6. Buttttt that doesn't really matter since they push so little air my system starts to throttle 20minutes into a game or work.. definitely going to have to get new fans or risk destroying my new pc parts.

I'm just getting into the RGB craze and I can say this kit works great with my new build based on an ASUS ROG Strix x470-F gaming motherboard. The included hub works great for RGB sync using ASUS' Aura and the fan PWM header to control the included 3 fans works exactly as it should for fan tuning. The fans are quiet under idle and ramp up but are still relatively quiet. The one improvement can be on where the FAN RGB circle is, with this model its on one side and with the mounting position for airflow intake, some of it is obstructed by the back, airflow is RGB side -> to fan back.

The fans are working and look great, but if you are not used to hearing a hum while using your computer, you're in for a treat.

The media could not be loaded. So far I've had these in my build for about a week and I'm pleasently surprised by their amazing performance. I was looking for a set of RGB fans that looked nice without breaking the bank and these fit the bill perfectly. The ring style RGB is far superior to the center style RGB of most other fans at this price point. Fairly smooth effect, solid performance and the easy to use controller make these a good buy. The extra RGB strips were a nice touch too. For the money, you can't go wrong

Pros:- Look super nice- Good RGB/fan controllerCons:- Fans themselves move very little air even at high RPM